Epoxy.com Product #100

Anti-Moisture Entrapment Epoxy

DESCRIPTION

Epoxy.com Product #100 Anti-Moisture Entrapment Epoxy uses a unique epoxy technology which allows the contractor to install epoxy systems on new concrete (4-5 days old) without fear of moisture entrapment. Product #100 Exhibits greater than 100 times the permeability of standard epoxy slurries and mortars. Product #100 is used as a base for Epoxy.com Chip and Quartz systems and as a binder for Epoxy.com Resinous Mortar Systems, when moisture is a concern.

ADVANTAGES

High moisture tolerance may reduce moisture transmission
Exhibits greater than 100 times the permeability of standard epoxy slurries and mortars
Excellent Ultra-Violet stability
Bonds well to cool, damp substrates

CONSIDERATIONS

	Substrate temperature must be a minimum of 50 degrees F.
	Substrate must be free of dirt, waxes, curing agents, and other foreign materials

COMPOSITION

Epoxy Resin, Polyamines, and Fillers

Colors

Product #100 is available in Gray. Special colors available, but minimum quantities and surcharges for special colors may apply.

APPLICATION

Surface Preparation

Surface preparation is the most critical portion of any successful resinous flooring system application. All substrates must be properly prepared as outlined in Epoxy.com Surface Preparation Procedures. Epoxy.com Technical Support Department is pleased to answer any questions.

Installation

Installation of Epoxy.com Product #100 varies with application needs. Typically, Product #100 is installed as a slurry with a flat or notched trowel. Spiney rollers are required to de-air mix after spreading. For specific instructions contact Epoxy.com Technical Service Department.

Cleanup

Clean skin with soap and water. Tools and equipment should be cleaned with xylene or lacquer thinner.

Coverage

12 Square Feet per gallon yields 1/8 inch. 24 Square Feet per gallon yields 1/16 inch.

MAINTENANCE

If the floor becomes slippery due to animal fats, oil, grease, or soap film, clean and rinse thoroughly. Epoxy.com Product #100 is easily cleaned with neutral soaps or detergents. Routine mechanical scrubbing is recommended for all surfaces having a non-skid texture. Waxing is optional. Long periods of heavy traffic may cause wear patterns necessitating a maintenance application of a finish coat.

Technical Data

Viscosity @75 Degrees F	3,500 CPS
Mixing Ratio	By Volume: 1 Parts A to 5 Part B
Solids Content	85% by volume
Volatile Organic Content (VOC)	-0-
Weight per gallon	11-11.5 pounds per gallon mixed

Cure/Dry Time

Pot Life	45 minutes @ 75 degrees F
Dry to Touch	4-5 hours @ 75 degrees F
Re-Coat	8-12 hours @ 75 degrees F
Light Traffic	Overnight
Final Cure & Maximum Resistance	5 days

Available in 3 gallon units consisting of 0.5 gallons of "A" and 2.5 gallons of B.