Epoxy.com Product #1200
Epoxy Organic Zinc Rich Primer
DESCRIPTION
Epoxy.com PRODUCT #1200 Epoxy Organic Zinc Rich Primer is a two component epoxy primer which provides both barrier and sacrificial protection against steel corrosion. PRODUCT #1200 promotes adhesion, dries rapidly, and can be either shop or field applied.
This product cannot be shipped to CA, IL, IN, ME, MD, NH, NJ, NY, OH, PA, RI, VT, VA, and DC due to VOC regulations. Contact Epoxy.com Technical Support for an alternate product if your project is in one of those states.
ADVANTAGES
| Meets SSPC Paint Specification no. 20, Type II. |
| Bonds tenaciously to metal. |
| Promotes adhesion of subsequent coats. |
| Provides excellent solvent and chemical resistance. |
| Can be shop or field applied. |
PHYSICAL PROPERTIES
| Color | Gray |
| Tack Free Time | 60 minutes @ 72°F (22.2°C) |
| Pot Life | 360 minutes @ 72°F (22.2°C) +/- 2° |
| Solids | 58% by volume |
| Solids | 88% by weight |
| Total zinc dust by weight of solids | 90% |
| Finish | Flat |
| Viscosity | 100 Krebs units |
| VOC | 2.95 lbs / gallon |
| Dry Temperature Resistance Without Topcoating. | Continuous 300 degrees F Intermittent 400 degrees F |
SURFACE PREPARATION
Steel Surfaces: Steel surfaces should be abrasive blasted to a commercial gray metal finish as specified by the Steel Structures Painting Council SSPC SP-6. All work blasted shall be coated the same day with Epoxy.com PRODUCT #1200 Zinc Rich Primer.
MIXING
Stir Component "A" thoroughly before combining with Component "B". Combine 5 parts by volume Component "A" to 1 part by volume Component "B". Mix for not less than three (3) minutes, using slow speed drill (300 to 600 rpm) and Epoxy.com -Mixing Paddle. When mixing has been completed, cover mixed material tightly and allow an induction time of not less than 45 minutes before application. Re-stir prior to application.
APPLICATION
Epoxy.com PRODUCT #1200 Epoxy may be applied by brush, roller, or spray. Stir intermittently during application to prevent zinc settlement. All spray equipment must employ traps to prevent water and oil from contaminating coating. Wait a minimum of 16 hours or a maximum of 5 days before subsequent coatings are applied. The recommended dry film thickness of 2.5 to 3.5 mils.
COVERAGE
Epoxy.com PRODUCT #1200 will cover approximately 275 SF (25.55 m2) per gallon depending upon surface texture to obtain 2.5 mils dry film.
PACKAGING
1 gallon kits.
CAUTION
DANGER! FLAMMABLE! Contains xylene. Keep away from heat, sparks, and flame. Avoid breathing vapor. Use with forced air ventilation in confined areas. Avoid contact of resin or hardener with skin or eyes. In case of eye contact, flush immediately with plenty of water and consult a physician. Do not take internally.
FOR INDUSTRIAL USE ONLY. KEEP AWAY FROM CHILDREN
-->