Epoxy.com Product #32
Flexible Epoxy Membrane and Mortar
Epoxy Crack Isolation System for most Epoxy.com Flooring and Coating Systems
Epoxy.com Product #32 Flexible Epoxy is a flexible resin used
as an epoxy membrane and as a flexible epoxy mortar. Epoxy.com Product #32
Flexible Epoxy is a two component, 100% solids epoxy used as a base in many
Epoxy.com Flexible Epoxy Floor and Mortar Systems. Flexible Epoxy resists
cracking caused by horizontal substrate movement, providing a crack resistant,
resilient, sound absorbent, waterproof, durable floor.
Epoxy.com Product #32 Flexible Epoxy offers stress-relieving
properties for floor slabs that show movement or vibration. Product #32 Flexible
Epoxy is excellent for use in areas such as mechanical equipment rooms, large
animal rooms and activity centers.
- Crack Resistant - Elasticity Allows Substrate Movement
- Ultimate Elongation of 140-150%
- Moisture Insensitive
- Reduces Noise Created by Mechanical
- Good Shock Absorption Qualities
- Good Chemical Resistance
- Meets USDA requirements
Surface must be clean and sound. Remove all dirt, laitance,
grease curing compounds and other foreign matter by sandblasting, shot blasting,
or mechanical abrasion. Remove water and dust from all surfaces with an oil-free
blast immediately prior to application. See Epoxy.com
Surface Preparation Guide for more details.
MIXING AND INSTALLATION INSTRUCTIONS
Application of Epoxy.com Product #32 Flexible Epoxy can be applied with brush
roller or spray. When spraying back-roll to ensure good contact with surface.
One coats at a minimum thickness of 32-40 mils each (40-50
square feet per gallon) is recommended. Do not use in temperatures below 50
degrees F, as cooler temperatures delay hardening.
Prolonged or repeated exposure may cause eye and skin
irritation. If contact occurs, wash immediately and seek medical help. Use
safety glasses with side shields and wear protective rubber gloves.
All tools and equipment should be cleaned before the system
gels. Use MEK, Acetone, or any lacquer solvent.
APPLICATION PROPERTIES @75° F
||1:1 by volume
|Full Set Time||48-72 hours|
|Final Cure - Max Resistance
|PHYSICAL AND PERFORMANCE PROPERTIES
|Tensile Strength (ASTM C-307)
|Ultimate Elongation (ASTM D-412)
|Volatile Organic Content (VCC)
(EPA Method 24)
|25 g/l, Compliant to low VOC|
Rule 1113 in all 50 states
|Adhesion to Concrete (ASTM D-7234)
||350-400+ psi (Concrete Fails)
|Thermal Cycling ASTM C884
|Flammability ASTM D635
|Hardness Shore A (ASTM
|Hardness Shore D (ASTM
|Impact Resistance (ASTM D-2794)
||16 ft. lbs.